SikaTop® Armatec®-110 EpoCem®

• Testing of chloride diffusion
• Determination of the shear-compression behaviour as bonding primer between existing concrete and green concrete

Portland cement, epoxy resin, selected aggregates and additives

12 months

Store properly in undamaged original sealed packaging, in dry cool conditions between +5 °C and +25 °C.

A+B+C density: ~2.0 kg/l at 23 °C

0.1 mm

SikaTop® Armatec®-110 EpoCem® is part of the Sika® repair system complying with the relevant part of European Standard EN 1504 and comprising of:

+5 °C minimum / +30 °C maximum

+5 °C minimum / +30 °C maximum

~ 3 hours (at +20 °C)

As reinforcement corrosion protection coating:

Minimum waiting time between 1st and 2nd working step:

Between 2nd working step and further coatings:

Between 2nd coat and repair concrete:

     
As a bonding primer:

Maximum waiting time before applying repair mortar

As reinforcement corrosion protection coating:
~ 2 kg per m² and application layer (~1 mm thick)
In total minimum 2 layer thickness (~2 mm thick)
   
As a bonding primer, substrate:
~ 2 kg per m² /mm dependent on substrate conditions

SikaTop® Armatec®-110 EpoCem® can be mixed with a low speed (250-350 rpm) electric drill mixer.
Shake components A and B thoroughly before opening. Pour liquid components A and B into a suitable mixing vessel and mix for 30 seconds. While still mixing components A and B slowly add powder component C. Mix the three components together for a minimum 3 minutes, minimising addition of air.

As reinforcement corrosion protection:
Using a suitably clean brush or spraying equipment apply a first layer to cover the reinforcement bars approximately 1 mm thick. When first coat is hard to the finger nail apply second layer approximately 1 mm thick.
    

As a bonding primer:
Apply using medium hard brush or spray gun to prepared substrate. To achieve good bond, SikaTop® Armatec®-110 EpoCem® must be applied well into the substrate, filling all pores. 

Clean all tools and application equipment with water immediately after use. Hardened material can only be mechanically removed.