Sika® Icosit® KC 330 Primer

1-pack polyurethane

12 months from date of production

The product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +10 °C and +25 °C. Always refer to packaging.

• SikaCor®-299 Airless (Steel deck / baseplate / rail coating)
• Sika® Icosit® KC 330 Primer
• Icosit® KC 330 / 340 products

Long-term resistant against:

• Water
• Many detergent solutions
• Seawater

Temporary resistant against:

• Mineral oil, Diesel fuel

Short-term or no resistance against:

• Organic solvents (esters, ketones, aromates) and alcohol
• Concentrated lyes and acids

Contact Sika Technical Services for specific information.

Dry heat short-term up to ~+150 °C, liquids up to ~ +60 °C

-40 °C min. / +80 °C max.

short term up to 150 °C

Condition product before application preferably at ~+15 °C

+5 °C min. / +35 °C max.

30 % min. / 70 % max.

Beware of condensation. The substrate and uncured applied material must be at least +3 °C above dew point.

+5 °C min. / +35 °C max

≤ 3 % parts by weight

Contents of opened container should be used within the same day.

At 40 % - 60 % relative humidity

~ 0,1 kg/m² - 0,2 kg/m²

Depends on the roughness and absorbency of the substrate.

Substrate must be sound, free from oil, grease, loose and friable particles.

Concrete tensile strength ≥ 1,5 N/mm².

Cementitious substrates must be prepared mechanically using suitable abrasive blast cleaning or planing / scarifying equipment to remove cement laitance and achieve an open textured gripping surface.

Weak cementitious substrates must be removed and surface defects such as blow holes and voids must be fully exposed and filled / repaired with compatible Sika® products.

Steel substrates must be prepared mechanically using suitable abrasive blast cleaning to remove all corrosion products and achieve a bright metal finish.

All dust, loose and friable material must be completely removed from all surfaces before application of the product and associated system products, preferably by vacuum extraction equipment.

Clean all tools and application equipment with Sika® Reinigungsmittel-5 immediately after use. Hardened material can only be removed mechanically.